12v LED Lighting Kit & Driver For 3D Printer Print Photo Enclosures Octoprint Pi

This is used to take a microcontrolled (arduino / raspberry pi) low voltage GPIO signal and control a higher voltage/current load.

Designed for use with octoprint and the LED Strip plugin on a 3D Print Enclosure - It will work fine with any microcontroller though.

There are 4 x RGBW Strips (Dedicated White LEDS) 18 LEDS Per Strip (Approx 30cm Each) To allow almost shadowless timelapse photos.

Fast switching MOSFets allow accurate PWM response without flickering.

If using a raspberry pi extra software setup is required to use the onboard gpio pins without flickering.

All connections are labelled

Includes High Quality 12v Switching Power Supply

The strips include quality adhesive backing. The surface needs to be perfectly clean and dry before applying.

If used in a high temperature environment we recommend using clips or other mechanical fixings to secure the strips

Whilst designed for a printer enclosure we have had customers use for photograph lighting.

With the dedicated white channel the strips are good for creating any shade of any colour.

PLEASE NOTE - A MICRO CONTROLLER IS REQUIRED WITH 4 FREE PWM CAPABLE GPIO PINS