3D Printer Direct Wire Pi Controlled PWM Power Supply 12V LED Strip & Fixings

Here we have a custom Direct Wire Power Supply / Convertor For Our Printer LED Strips

Designed for 3D Printers With a 12 or 24v Power Supply and Octoprint but suitable for any 12 / 24v source and almost any controller

Will Easily Power A Fair Few LED Strips, Fans Or Most Other 12V Kit

Connect the bare wires to the power supply output and plug the power wire into our strip light kits.

Connect the single control wire into a controller (3.3v, 5v & 12v) and off you go.

This will switch the 12v output on when the control signal goes low

Works with Raspberry Pi, Octoprint, Arduino or basically any controller & software that allows control of the GPIO pins.

This will allow PWM control of most 12v things :)

The 3D Printed Case has mounting tabs and fixings designed to mount on the rails of most 3D printers.

We have ours fixed on the under / internal support rails along with our octopi.

28cm power supply wire, 80cm LED power wire and 70cm control wire.