5v, 12v, 24v LED Driver / Controller. Give Your Microcontroller PWM Control 4Ch

This is used to take a microcontrolled (arduino / raspberry pi) low voltage GPIO signal and control a higher voltage/current load.

Designed for use with octoprint and the LED Strip plugin on a 3D Print Enclosure - It will work fine with any microcontroller though.

There are 4 x RGBW Strips (Dedicated White LEDS) 18 LEDS Per Strip (Approx 30cm Each) To allow almost shadowless timelapse photos.

Fast switching MOSFets allow accurate PWM response without flickering.

If using a raspberry pi extra software setup is required to use the onboard gpio pins without flickering.

All connections are labelled and the output is a standard LED strip connector so will plug straight in to most RGBW or RGB strips (RGB Strips just omit the White channel when connecting)

If using a 12v LED strip then a 12v Power Supply is required, 5v for 5v and 24v for 24v strips.

Whatever voltage goes into the input, this is what will be controlled to the output.

Make sure your LED and PSU match.

Power input is a standard 2 pin jst connector but can be supplied with a 2.5mm barrel connector if using a wall power supply. Please leave us a message when buying if required.

PLEASE NOTE - A MICRO CONTROLLER IS REQUIRED WITH 4 FREE PWM CAPABLE GPIO PINS