G3D Print Fix Adhesion AID Set - Dual Spray KIT For Heated Glass 3D Printer Beds

Used to aid print adhesion when printing plastics. We use this for small ABS prints and all our PLA & PETG prints. When used with our glass printing plates adhesion is no longer a problem.

Hold the glass plate vertical in the air and apply the print fix by shaking well before spraying 2-3 times from 20-30cm away. Once heated you will be left with a slightly sticky bed which your print will attach to, helping to prevent warped prints/lifting corners.

You will get a few prints off this without doing anything. To increase the life of each application a couple of sprays from the water atomiser directly to the printing plate will help out significantly.

Print fix is water based and easily cleaned with a damp towel between applications. Always be sure to allow your print to cool before attempting removal. Failure to do this can damage the glass surface. Once cooled your print should come away with little to no effort. Any residue left on the printed part can be wiped or washed off.

If you're printing with a 3D printer you probably know how frustrating it is to get the perfect first layer, every time, and then have it stick.

After trying the majority of adhesion options out there we stumbled upon this mix that has reduced our failed prints to nearly zero. We now use this on all our printers.

The spray helps to prevent the liquid pooling during application and ensures an even covering.

Being water based with pump action spray its good for your pocket and also for the environment. No solvents or aerosols here. The sprays are also refillable meaning you only buy the sprays once and then refill them yourself, saving a few more pennies.

Included Is:

1x 50ml Print Fix Spray
1x 50ml Water Spray